產品分類 更多>>
225/330bar, 100 l/min
Model JUNIORII型號
Technical Data for Compressor Block:
壓縮機主機技術參數：
Medium : 壓縮介質 | Air |
Intake Temperature : 進氣溫度 | +5 to +45°C |
Ambient Temperature : 環境溫度 | +5 to +45°C |
Nominal Pressure max. : 公稱壓力 | 330 bar adjusted by safety valve |
Working Pressure : 工作壓力 | 225/330 bar (Choice one pressure) |
Capacity : 流量 | 100 l/min |
Speed : 轉速 | 2300 1/min |
Number of Compression stages : 壓縮級數 | 3 |
Number of Cylinders : 汽缸數 | 3 |
Power consumption at max. pressure 壓力時的功率消耗 | 2.2 kW |
Drive : 驅動方式 | V-Belt |
Technical Data for Prime Mover:
驅動電機的技術參數：
Type : 型號 | three phase electric motor |
Power : 功率 | 2.2 kW |
Speed : 轉速 | 1450 1/min |
Enclosure : 防護等級 | IP55 |
Voltage: 電壓 | 200-240V |
Frequency : 頻率 | 60 Hz |
Standard Scope of Supply:
· COMPRESSORBLOCK
· 壓縮機主機
- Oil pump for forced-feed lubrication with oil filter
油泵帶油濾器作注油式潤滑
- Oil sump content: For blocks i100.x:0.36
油池容量：主機I100x: 0.36升；
- Micronic intake filter
進氣濾芯
- Interstage coolers, air cooled after each stage
每級壓縮后都設有冷卻器
- Aftercooler, air cooled, outlet temp. approx. 10-15 °C above ambient temp.
壓縮氣體經過冷卻器后的溫度大約高于環境溫度10-15 °C
- Intermediate oil/water separators after each stage
每級壓縮后都設有中級水油分離器
- Final oil/water separator
終級水油分離器
- Safety valves after each stage
每級壓縮后都設有安全閥
- Final pressure safety valve
終級安全閥
- Pressure maintaining and check valve before compressor outlet
壓縮機出口前設有壓力維持閥及單向閥
- First oil filling with final test
壓縮機已加注潤滑油并經過整機運行測試
- Oil change 2000 hours or 2 years whichever comes first
潤滑油更換時間為運行2000小時或兩年（二者以先到為準）
BAUER air quality is better than the most stringent standards DIN EN 12021:
寶華空氣質量優于最嚴格的DIN EN 12021標準：
BAUER standard指標 | DIN EN 12021 standard 標準 | |
油分Oil | ＜0.1mg/m3 | ＜0.5mg/m3 |
一氧化碳CO | ＜5ppm | ＜15ppm |
水分Water | ＜10mg/m3 | ＜25mg/m3 |
-P21 filter system:
- P21過濾系統:
Purification system by TRIPLEX, TRIPLEX long filter, pressure retaining valve / non-return valve and the end relief valve.
由TRIPLEX凈化系統，TRIPLEX長效濾芯，保壓閥/單向閥和終級安全閥組成。
-330bar inflatable device
- 225/330bar 充氣裝置
BAUER 200/250/300 with 1 charging connector
BAUER 200/250/300帶有1個充氣接頭
Each charging connector includes: 1 root 1 meters long filling pipe
1 with the emptying function of pneumatic valve, pneumatic bottle joint is 5/8 BSP, DIN EN144-2 1 pressure gauges
每個充氣接頭包括： 1根1米長充氣管
1個帶有放空功能的充氣閥，充氣瓶接頭是5/8 BSP, DIN EN 144-2
1個壓力表
